Can Bounce command be used from the command line?

[Jon LaBadie]

Some messages I receive my wife should see also.  Rather than
"Forward" ("f" command) them, I typically "Bounce" ("B" command)
them to her.

I would like to automate this procedure for certain sender addresses
so I'm developing a procmail recipie.

Is there a way to use mutt from the command like to "Bounce" a
received message.  I had hopes for the '-e "command"' option, but
that is limited to configuration commands.

Thanks,
Jon

-- 
Jon H. LaBadie                 jon at labadie.us
  11226 South Shore Rd.          (703) 787-0688 (H)
  Reston, VA  20190              (703) 935-6720 (C)